Diono radian 3RX Mode D'emploi page 32

SECURING YOUR CHILD
1. Loosen harness straps. Push down on the harness
adjuster while pulling out on the harness straps
at the chest clip. Unbuckle the chest clip and the
center buckle. Place harness straps off to the sides.
2. Place your child in the seat. Make sure their back
is flat against the car seat back (this can be done
in or out of the car). Avoid bulky or heavy clothing
because they will prevent the harness straps from
being tightened properly.
NOTE: Diono recommends harnessing your child
first and placing a blanket over them or putting
their jacket on backwards.
3. Be sure the harness straps are at the proper
height.
WARNING:
All harness slot positions can be used
rear-facing, however, only use the top three
shoulder harness positions for forward-facing.
62
radian 3RX
Rear-Facing
Harness straps MUST be
at or just below the child's
shoulders. Top of head
must be at least 1.5 in.
(3.8 cm) below the top of
the car seat shell.
4. Place harness straps over child's shoulders and
REAR-FACING
legs and buckle. You will hear a "click" when buckle
tongues are securely attached. Pull up on each
buckle tongue to make sure it is securely attached.
5. Pull up on center buckle strap to make sure it is
secured.
6. Pull all the slack out from around the waist. Pull
up on the harness strap while pushing the chest
clip down. Do this to both sides.
diono.com
SECURING YOUR CHILD
Forward-Facing
Harness straps MUST
be just above the child's
shoulders. Top of child's
ears MUST be below top of
car seat shell.
FORWARD-FACING
63