Diono radian 3RX Mode D'emploi page 28

LAP BELT CUSHION
FOR U.S. INSTALLATIONS ONLY!
DO NOT USE FOR CANADA INSTALLATIONS!
This lap belt cushion should
harnessed forward-facing installations using a
LAP BELT ONLY with NO top tether available
22–65 lb (10–29.5 kg).
DO NOT USE REAR-FACING.
WARNING: You MUST use the 5th
harness slot when using the lap
belt cushion.
54
radian 3RX
ONLY be used for
from
5
FOR U.S. INSTALLATIONS ONLY!
To install the Lap Belt Cushion:
1. Remove the center buckle pad
by pulling it carefully up and
over the buckle.
2. Unclip seat cover from seat
bottom. Lift seat cover away
from the seat bottom and
remove the buckle.
3. Place lap belt cushion on seat
bottom, and slide the buckle
through the slot in the cushion
that matches the slot position
being used on the seat.
4. Guide buckle through seat
cover bottom and memory
foam cushion. Reattach cover
to seat bottom.
5. Reinstall the center buckle
pad. Should you need a longer
buckle, these are available by
calling Customer Care.
diono.com
1
2
3
55