Diono radian 3RX Mode D'emploi page 27

4. Slide the vehicle seat belt
through the forward-facing belt
path and out the other side.
Buckle it. The seat belt should
lie as flat as possible and not be
twisted.
5. Tighten the vehicle seat belt.
Slowly pull the lap/shoulder
belt all the way out and then
let it go back in. You will hear
a clicking sound as the belt
retracts. Slowly pull out on the
belt and it should be locked. If
not, please review your vehicle
owner's manual.
Press down firmly in the center
of the car seat. To tighten, pull
from the lap/shoulder belt on
the side nearest to the buckle
while feeding the slack back
into the retractor.
52
radian 3RX
6. Tighten the top tether strap.
4
7.
5
Push the car seat back while
tightening the tether strap to
remove all the slack.
Test for tightness.
Grab the side of the seat with
one hand where the seat belt
strap is and slide the car seat
side-to-side and front-to-back.
If the seat moves less than 1 in.
(2.5 cm), it is tight enough. Do
not test by grasping the top or
front of the seat.
diono.com
6
7
53