Diono radian 3RX Mode D'emploi page 24

TOP TETHER
ALWAYS Use the top tether
forward-facing.
A tether is designed to reduce
movement of a forward-facing
child restraint in a collision.
Vehicle tether locations can be found in many
locations within the vehicle. Some of the typical
locations are shown here. Please refer to your vehicle
owner's manual for exact locations, requirements,
and anchor identification points.
FORWARD-FACING TOP TETHER INSTALLATION
REAR SHELF
BACK
WALL
BACK OF
SEAT
FLOOR
OF VEHICLE
46
radian 3RX
INSTALL USING LATCH/UAS: 22–40 lb (10–18 kg)
DO NOT install by this method for a child weighing
more than 40 lb (18 kg). Reinstall with vehicle belt
for weights between 40–65 lb (18–29.5 kg).
1. Remove LATCH/UAS strap
from storage location
back of seat. Use LATCH/UAS
release on the LATCH/UAS
connectors to remove.
2. Extend the LATCH/UAS
strap. For easier installation,
extend the LATCH/UAS strap
to its maximum length by
pressing the grey button and
pulling on the strap.
diono.com
1 on
1
1
2
47