Scheppach Basa 5.0 Traduction Du Manuel D'origine page 26

The machine is not completely assembled
for reasons of transport.
Assembly tools:
13 mm fork wrench
5 mm hexagonal socket wrench
(not included in delivery)
Guide pipe
Fig."2"
The fence plate underneath the sawblade
has been fitted in the works.
Before attaching the guide tube, check
the fence plate for tight fit.
If necessary, tighten the clamping levers (1).
Fit the steel holding devices for the guide tube at
the lett and right-hand side of the fence plate.
2 cheese head srews
2 washers
2 steel holding devices
Push the gu!de lube mto the holding devices from
the side. Before tightening the hexagon boIts,
check the parallelity of the guide tube with the
GB
table (dimension „x").
Dimension „x" must be identical at the front
and at the rear of the table.
Fence
Fig. „3"
• The fence can be used to the Ieft or
the right of the saw band depending
on wone requirements.
Screw together the feace pipe, intermediate plate,
and guide slide (handscrewed). To da this, insert
both threaded screws into the guide slots.
4 washer
4 cheese head screws
The electrical current supply is interrupted by a
limit switch when the housing lid is opened!
Cutting speeds
Fig. „6"
Band saw are quipped with 2 cutting speed.
IMPORTANT!
The cutting speed may only be set while the
machine is at a full stop. Pull the mains plug!
Montage
M8 x 16
6
M6x20
Setting before inital operation
• The divider plate to carry the fence is
screwed onto the fence pipe on the
right or the Ieft depending on the work
requirements.
Do not tighten the wing nuts!
2 saucer-head screws
2 washers
2 wing nuts
Place fence rail onto the divider plate.
Position 1: for work with a higher contact surface
Position 2: for work with a lower contact surface
Place the cam lever on the guide slide horizontally.
Place the guide slide onto the guide pipe and push
the cam lever down - c!amp.
On the guide pipe, the upper scale applies to
position 1; the Iower scale to position 2.
Fence adjustment
Fig."4"
Place the fence on the guide rail.
Place a straight strip on the sawband running
upwards and downwards.
Place an angle on the strip and on the fence.
Adjusting the reading glass
Fig."5"
The guide tube must project over the sawblade to
such an extent that the scale on the guide tube is
positioned directly under the zero mark of the
magnifying glass.
Release the two belts of the magnifying glass and
set the graduation mark precisely above the
zero mark of the scale.
Retighten the bolts of the magnifying glass.
Two levels
460 m/min. for wood and hardwood
775 m/min. for soft wood
V-belt 10 x 1072 mm
Cutting speed - levels I - II
463 m/min. 1 to 3
775 m/min. 2 to 4
The machine is delivered with apre-set
cutting speed of 775 m/min for wood and hard-
wood
GB
M 6 x 75
6
M6