Vermeiren Interval Mode D'emploi page 17

3.3.3 Head part / foot-end
1. Fit the supports for the headrest and the foot-end by means of the screws and
washers provided (preparatory assembly).
2. Insert the wooden uprights in the end tubes of the slatted frame and secure them
with the fixing screws.
3. Push the guide rails for the side railings with the sharp edge pointing upwards into
the guide rails of the head and foot sections until fully engaged.
3.3.4 Wooden side railings
Insert the short bolt rails (1) on the right and left in the upper wooden slat. Insert the
A.
long bolt rails (2) right and left in the lower wooden slat.
Insert the long bolt rails (2) in the wooden slat in the sliding rail for the head and
foot section one by one and secure them by inserting the rails until the upper end is
inserted and clicks. On one side release this rail again until the tip by pressing the
position locking button (5) and pulling the upper wooden slat gently upwards.
Let the bolt rails (2) fall from the sliding rail once more until the tip of the rail is just
barely in the guide. The short bolt rail (1) can now be inserted together with the
wooden slat between the walls of the long bolt rails and the entire bolt rail system (1)
+ (2) can be placed in the relevant sliding rail (4) by pulling upwards when grasping
only the upper wooden slat and then locking the structure in position.
Insert the locknuts (6) and tighten them manually.
B.
Interval, Interval 120cm, Interval 140cm
1 = Support for headrest / foot-end
2 = Fixing screws
3 = Sliding rail
4 = Guiding rail for side railings
5 = Arresting knob
1 = Short bolt rails
2 = Long bolt rails
3 = Wood slats (2 pieces each side)
4 = Sliding rail
5 = Position locking button
6 = Locknut
!"#$%&*%
EN
2011-01