Maintenance And Repairs; Disposal And Recycling; Troubleshooting - Scheppach HSC130 Traduction Des Instructions D'origine

11. Maintenance and Repairs

• Maintain the device regularly to ensure the
error-free function.
• In the case of problems, place the device
out of service immediately and, if necessary,
have it repaired by an authorized specialist.
• Perform a visual check of the block splitter
before every use.
• After every use of the block splitter, remove
trash and stone remnants.
• Lubricate or oil all moving parts regularly with
grease or motor oil.
Service information
Please note that the following parts of this prod-
uct are subject to normal or natural wear and
that the following parts are therefore also re-
quired for use as consumables.
Wear parts*: blade
* Not necessarily included in the scope of de-
livery!

13. Troubleshooting

Problem
Stone doesn't break
Material doesn't lie flat
Cutting lever won't move
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Heruntergeladen von manualslib.de
Possible cause
Blade worn out
There are stone chips on the support
Stone chips in moving parts
Handbücher-Suchmachiene

12. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories
are made of various types of material, such
as metal and plastic. Defective components
must be disposed of as special waste. Ask your
dealer or your local council.
Remedy
Change blade
Clean the support
Clean block splitter
GB | 19