Work And Safety Instructions - Festo 8064284 Brève Description


The MPS may only be used:
•
For its intended purpose
•
When its safety functions are in perfect condition.
Malfunctions which may impair safety must be eliminated immediately!

5 Work and safety instructions

General safety
•
Trainees should only work with the circuits under the supervision of an instructor.
•
Electrical devices (e.g. power packs, compressors and hydraulic units) may only be operated in training
rooms that are equipped with residual current devices (RCDs).
•
Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!
•
Malfunctions which might impair safety must not be generated when the device is operated for training
purposes.
•
Wear personal safety equipment (safety glasses, safety shoes) when working on circuits.
Mechanical safety
•
Switch off the power supply!
– Switch off working and control power before working on the circuit.
– Only reach into the setup when it's at a complete standstill.
– Be aware of potential overtravel times for the drives.
•
Mount all of the components securely on the profile plate.
•
Make sure that limit valves are not actuated from the front.
•
Risk of injury during troubleshooting!
Use a tool such as a screwdriver to actuate limit switches.
•
Set all components up so that it's easy to activate the switches and interrupters.
•
Follow the instructions about positioning the components.
© Festo Didactic 8064398
DC Motor Controller
21