Transporting The Chain Saw; Battery Safety - Oregon CS250 Manuel D'instruction

SAFETY RULES

TRANSPORTING THE CHAIN SAW

Remove the battery pack from the saw
and install the blade cover Clean the saw
thoroughly and if desired, drain the bar
and chain oil to reduce seepage
TRANSPORTING THE BATTERY PACK
Observe national regulations when
shipping lithium ion batteries Special
package labeling may be required
BATTERY PACK DISPOSAL
Do not dispose of battery pack in
household garbage or incinerate Local
waste management and recycling
agencies have information on proper
recycling or disposal instructions Battery
packs can be collected in the United
States or Canada through Rechargeable
Battery Recycling Corporation OREGON®
has already paid the costs involved to
recycle battery packs Return end of life
battery packs to participating retailer or
recycling center Return locations and
more information can be found at
www call2recycle org or 1-800-8BATTERY
10
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250

BATTERY SAFETY

DANGER: FAILURE TO FOLLOW
THESE SAFETY RULES CAN
CAUSE THE BATTERY PACK TO
LEAK HAZARDOUS CHEMICALS,
OVERHEAT, EMIT SMOKE, BURST,
FLARE, EXPLODE, AND/OR IGNITE.
CAUTION: DO NOT DISPOSE
OF THE BATTERY PACK IN THE
HOUSEHOLD WASTE OR FIRE.
LITHIUM ION BATTERY PACKS
SHOULD BE RECYCLED BY LOCAL
AUTHORIZED RECYCLER.
CAUTION: DO NOT EXPOSE
BATTERY PACK TO EXCESSIVE
HEAT, SUCH AS THE INTERIOR OF A
VEHICLE IN HOT WEATHER. SUCH
EXPOSURE CAN CAUSE A LOSS IN
PERFORMANCE AND/OR SERVICE
LIFE. DO NOT ATTEMPT TO RE-
CHARGE A NON-RECHARGEABLE
BATTERY PACK.
• Do not disassemble or modify the
battery pack The battery pack is
equipped with built-in safety and
protection features which may be
inadvertently disabled
• Do not connect the positive (+) and
negative (-) terminals with metal objects
Do not transport or store the battery
pack together with metal objects such
as coins or screws Short-circuiting may
occur or the metal object in contact
with the battery pack can generate heat
• Do not discard the battery pack into
fire or otherwise expose to excessive
heat Such conditions can cause the
insulation to melt or safety features to
be damaged
• Do not use, charge, or store the battery
pack near a heat source as fire or a
heater that generate temperatures
above 176°F (80°C) Overheating and/or
internal short circuiting may occur
AF 0513 - F/N 547361