RIDGID 920 Roll Groover Mode D'emploi page 8

920 Roll Groover
onto the drive shaft by using repeated and forceful
counterclockwise spins of the handwheel.
6. Lift each side of the groover and insert the legs into
the sockets located in the base. Install the hitch pins
(Figure 5) .
Figure 5 – Installing Legs Into the Groover Base
7. Turn the upper portion of the leg counterclockwise
until it makes contact with the ground. Adjust both
legs until the unit is level (Figure 6) .
6
Figure 6 – Adjusting Legs to Level Groover
8. Check that the groover is level and the unit is stable
(Figure 7) .
WARNING
sult in tipping.
Figure 7 – Leveling Groover
9. Install pump handle by screwing it into the elbow
(Fi gure 8) .
Ridge Tool Company
Failure to properly set up the unit may re -