SilverCrest SDB 1500 A1 Instructions D'utilisation Et Consignes De Sécurité page 40

Safety notices
Do not leave the device on the floor during or
after operation.
Never direct the jet of steam in the direction of
other devices which contain electrical compo-
nents (e.g. the inside of an oven).
Remove the plug from the socket when remov-
ing the pad from the steam jet. Wait for at
8
least 5 minutes until the steam base
pad have been allowed to cool.
8
If the mains power cable of this appliance is
damaged, it must be replaced by the manufac-
turer or its service department, or a similarly
qualified person to prevent hazards.
lead needs to be replaced, always
have the work performed by the
manufacturer or its service centre. This
will ensure the safety of the device.
Do not use any other high-consumers of power
(heaters, irons, radiators) on the same circuit.
Risk of overloading!
Do not place the warm parts of the device onto
the power cable.
Never pull the plug attached to the mains
cable from the socket.
4
The mains cable
with sharp objects or sharp edges.
Ensure that you do not run over the mains
cable with the device while it is switched on.
Otherwise there is a risk of injury.
Please ensure that the mains cable
not come into contact with warm parts.
Do not pull the device by the mains cable
Unplug the mains plug
when there is a storm.
Never wrap the mains cable
hand when the device is connected to the
mains.
ATTENTION!
DANGER OF MATERIAL DAMAGE!
Do not use the device for cleaning natural
wood, water-permeable wood, soft plastics,
wooden objects and leather products.
Do not use the device on glass surfaces.
Do not use the device is the pad
Risk of damage or scratching to the floor!
The device may not be used without a filter
40 GB
114903_silv_Dampfbesen SDB 1500 A1_content_DE_AT_CH.indd 40
and the
9
If the plug or mains
may not come into contact
4
does
4
4
from the socket
4
around your
4
is worn.
8
10
Always unwind the mains cable
prior to use.
Use of extension cables not specified by the
manufacturer can lead to damage and
accidents.
Never use the device without water as the
pump may otherwise burn through. Check the
water level in the water tank
Do not use sparkling water (with added
carbon dioxide). In cases of particularly hard
water (with a water hardness of more than
2 mmol / l), use a mixture of 50 % tap water
and 50 % distilled water.
Do not add any vinegar, descaling agent or
other perfumed substances to the water tank
Doing so will void the warranty.
Always remove the mains cable
plug before stowing away the device. Wait un-
til the device has completely cooled and empty
the water tank
11
Never use or leave the device standing
outdoors.
Possible modifications to the device which have
not been expressly permitted by the manufac-
turer can compromise the safety of the device
and lead to the warranty becoming void.
Do not use the steam broom on glass as the
hot steam can cause the glass to break.
For your own safety, check the device for dam-
age before each use. Cease use immediately
in the case of damage until the device can be
repaired by a specialist.
. Do not take the device apart or try to repair
damage yourself. Contact the customer service
team or a specialist.
Never concentrate the steam on one point for
too long.
Do not insert anything into the openings/jets of
the device and ensure that these do not
become blocked.
.
completely
4
regularly.
11
11
from the
4
.
09.06.15 08:55
.