Before You Start Using The Unit; Unpacking; Placement Of The Unit; Serial Number - Kemppi KEMPACT PULSE 2800 AUTOMOTIVE Manuel D'utilisation

2. BEFORE YOU START USING THE UNIT

2.1. UNPACKING

The equipment is packed in durable packages, designed specially for it. Nevertheless, before using
the equipment, always make sure it was not damaged during transport. Also check that you have
received what you ordered and it is accompanied by the appropriate instructions. NOTE! The
packaging material is suitable for recycling.

2.2. PLACEMENT OF THE UNIT

Place the unit on a horizontal, solid, and clean surface. Shield it from heavy rain and scorching
sun. Make sure that cooling air circulates freely.

2.3. SERIAL NUMBER

The serial number of the unit is marked on its rating plate. The serial number makes it possible to
trace product manufacturing series. You might need the serial number when placing spare parts
orders or when planning maintenance.

2.4. CONNECTION TO THE MAINS SUPPLY

The Kempact™ Pulse 2800 Automotive is delivered with a fi ve metre mains cable without a plug.
Installation of the plug should be carried out only by a competent electrician. For fuse and cable
sizes, see the technical data in the end of this document.

2.5. GROUND CABLE

Fasten the earth clamp of the return current cable carefully, preferably direct onto the piece to be
welded. The contact surface of the earth clamp should always be as large as possible.
Clean the fastening surface of paint and rust. Use at least two 35 mm² cables. Thinner cross sectional
areas may cause the connectors to overheat.
4 – KEMPACT™ PULSE 2800 AUTOMOTIVE / 0709 © KEMPPI OY