Adjustments, Display And Weld Data; Timer; Adjustment Of Welding Dynamics; Remote Control - Kemppi KEMPACT PULSE 2800 AUTOMOTIVE Manuel D'utilisation

Masquer les pouces Voir aussi pour KEMPACT PULSE 2800 AUTOMOTIVE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.3.3. Adjustments, display and weld data

The display for wire feed speed, welding voltage or material group. This can be switched using
the button under the display (wire feed speed/length of arc). The voltage can be adjusted in the
normal and 1-MIG position (wire feed range/the length of arc). During pulse welding the voltage
is determined by the wire feed speed while the length of arc affects some other parameters.
When pressed simultaneously, the weld data buttons recall the wire feed speed on the display, the
welding voltage and welding current values which have been used when welding was stopped.

3.3.4. Timer

intermittent welding
spot welding
The spot time is set immediately after pressing the switch button, on the display SPt.
The pause time is set accordingly, on the PSE display. The time is set using the Process
Manager.

3.3.5. Adjustment of welding dynamics

For adjusting of MIG/MAG welding dynamics, the adjustment value dyn -9...0...9 is
displayed. The welding stability and quantity of spatter are affected by the welding
dynamics control, the 0-position is the recommended reference range. Values -9...-1
give a smoother arc and less spatter, while values 1...9 give a rougher arc and increased
stability, when using a 100% CO ² shielding gas when welding steel.

3.3.6. Remote control

Gun control, wire feed speed or welding power control is changed using RMT 10.
Control of the welding voltage or the length of the welding arc can be adjusted using
the potentiometer on the panel. Panel control, adjustments using the potentiometer on
the panel.

3.3.7. Mig extra functions

Crater fi lling, 1-MIG and pulse MIG:
Crater fi lling reduces welding mistakes caused by end craters. The welding power and
end level can be changed using the SETUP-function.
10 – KEMPACT™ PULSE 2800 AUTOMOTIVE / 0709
Display for welding current and welding material
thickness. Changing can be made using the button
behind the display. There is a percentage display
(eg. gas consistency) and seconds display (see
timer). The relative length of arc will be displayed
when adjusted. Otherwise the predicted current
value is displayed (not in 2-MIG).
Process Manager™ for setting all welding
parameters.
© KEMPPI OY

Publicité

Table des Matières
loading

Table des Matières