Operation - Anova MG246 Manuel D'instructions

6 OPERATION

■
TO START THE ENGINE
Cold start: A "cold" start of the engine means starting it after at least 10
minutes after it was shut down or after refueling.
Unscrew the gas tank cap and oil cap completely, but do not remove
1.
them from the machine, just hang up.
Put fuel and oil into the fuel tank and oil tank up to 80% of full capacity.
2.
Firmly hold the two caps and wipe up any fuel spills around the unit.
3.
Continuously push the primer bulb until fuel enters the bulb.
4.
Turn the choke knob clockwise. The choke will close and the throttle
5.
trigger will be set to the home position.
When restarting immediately after stopping the engine assembly choke in the
open position.
Press the button on the decompression valve. (If equipped)
When the trip occurs, the decompression valve will return to the closed position
automatically, you must press the decompression valve button before each start.
Push the front handle guard down to activate the chain brake.
6.
While holding the chainsaw securely on the ground, grasp the starter handle,
7.
slowly pull the cord with your right hand until feel some resistance (the starter
pawls grab), and now, quickly and powerfully pull the rope. Never get your
hand caught in the rope.
When the first shot occurs, turn the choke knob counterclockwise to open it.
8.
Note: Adjusting the choke manually can temporarily adjust the throttle to a
partially open position for easier starting.
Hold the chain saw firmly on the ground, and repeat pulling the cord until the
9.
engine starts.
Lift the front handle shield toward the front handle to release the brake.
10.
Then let the engine warm up with the trigger pulled slightly.
Before starting the engine, make sure the saw chain is not in contact with
anything. Make sure the chain brake is always activated before every
start.