Anova MG246 Manuel D'instructions page 111

13. TROUBLESHOOTING
TROUBLE
1) Failure to start
2) Lack of force / poor
acceleration / uneven idle
3) The oil does not come out
Should the unit require additional overhaul service, consult an authorized ANOVA
service facility in your area.
CAUSE
-Replace the fuel in case of
finding water or another
mixture of inferior quality.
-Check for engine flooding.
-Check spark plug spark
-Check the fuel for water or
some inferior quality mixture.
-Check the air filter for clogs
-Check carburetor for
improper settings.
-Check for inferior quality oil
-Check the oil flow for any
obstruction
SOLUTION
-Replace with appropriate
fuel.
-Remove and remove the
spark plug wire.
-Then pull the starter again
without primer.
-Replace with a new one.
-Replace with appropriate
fuel.
Clean
Readjust needle speed
Replace
Clean