Anova MG246 Manuel D'instructions page 105

Before cleaning, inspecting, or repairing the unit, make sure the engine has stopped
and is cool. Disconnect the spark plug to avoid accidental starting.
Follow the instructions for performing regular maintenance, preoperative
procedures, and
Daily maintenance routines. Improper maintenance can cause serious damage to
the machine.
Keep your chain saw in good working condition at all times.
■
Maintenance after each use
Air filter
1.
Dust on the surface of the air filter
can be removed by tapping a corner
of the filter against a hard surface.
To clean the dirt on the screens,
divide the filter in half and brush with
gasoline. When using compressed
air, blow from the inside.
To assemble the filter halves, press the edge until it clicks.
Oil port
2.
Remove guide bar and check oil port for clogging.
(1) Oil port
Cutting sword
3.
When the guide bar is removed, remove the sawdust in the bar groove and
the grease hole.
Grease the nose sprocket from the feed hole at the tip of
the bar.
(1) Greasing port
(2) Grease port
(3) Sprocket
Four. Others
Check for fuel leaks and loose fasteners and damage to major parts, especially handle seals
and guide bar assembly. If you find any defects, be sure to rep
plow them before using the machine again.