Anova MG246 Manuel D'instructions page 98

IMPORTANT
It is very important to maintain proper chain tension. Rapid wear on the guide
bar or chain that comes off easily can be caused by improper tension.
Especially when using a new chain, take good care of it, as it must expand when used
for the first time.
The spiky bumper belongs to the chainsaw. It must be screwed into the chainsaw
before initial use. Please fix the spike bumper with two screws on the front of the
chain saw.
5. FUEL AND OIL IN THE MACHINE
■ Fuel
The engines are lubricated by oil specially formulated for the use of air-cooled 2-
stroke gasoline engines. If oil is not available, use a quality oil expressly labeled for
air-cooled 2-stroke engine use.
RECOMMENDED MIXING RATIO GASOLINE 25: OIL 1
These engines are certified to run on unleaded gasoline.
Gasoline is highly flammable. Do not smoke or bring flames or
sparks near fuel.
GASOLINE WITHOUT OIL (RAW GASOLINE) - Causes severe damage to the
1.
engine and its internal parts very quickly and can render the machine unusable.
OIL FOR 4-CYCLE ENGINE USE OR WATER-COOLED 2-CYCLE ENGINE USE -
2.
May cause ignition of the spark plug, blockage of the exhaust port or sticking of the piston
ring
■HOW TO MIX FUEL
1. Measure the amounts of gasoline and oil to be mixed.
2. Put some of the gasoline into a clean, approved fuel
container.
3. Pour in all the oil and shake well.
4. Pour in the remaining gasoline and shake again for at least
one minute.
Put a clear indication on the outside of the container to avoid mixing with gasoline or
others.
CHAIN OIL
Use special saw oil throughout the year.
Do not use waste or regenerated oils that can damage the oil pump.