Anova MG246 Manuel D'instructions page 108

File
diameter
Chain
type
2 3/1
1 6 "
B
P
X
Guide bar
• Reverse the bar occasionally to avoid partial and unbalanced wear of the
chain and bar.
• The bar rail should always be square. Check the bar rail for wear. Apply a
ruler to the bar and to the outside of a cutter. If there is a gap between them,
the lane is normal. Otherwise, the bar rail is worn. This bar needs to be
corrected or replaced.
(1) Ruler (2) Gap (3) No gap (4) Chain incline
Top plate
angle
Screw
rotation
angle
30°
Depth gauge
Lower
Inclination
angle
angle(55°)
Screw
Lateral
inclinatio
angle
n angle
10° 85°
Depth gauge
standard
0.025 "
lime