Maintenance - Anova MG246 Manuel D'instructions

Cut a supported log
In area A in the image above, saw from the
bottom one third and finish sawing from the top.
In area B, saw down from the top one third and
finish sawing from the bottom.
Delimbing a felled tree
First check in which direction the limb is bent.
Next, make a shallow cut on the compressed
side to prevent the limb from tearing. Cut
through the taut side.
Be alert to kickback from a cut branch
that is compressed or resisting
pressure.
Pruning
Cut from the bottom, finish from the top
Do not use an unstable base or ladder.
1.
Don't go too far.
2.
Do not cut above shoulder height.
3.
Always use both hands to tighten the saw.
4.
The spike bumper should always be put on while using the chainsaw
on the tree trunk. Push the spiked bumper into the trunk using the
rear handle. Push the front handle in the direction of the cutting line. The
pointed bumper should be fixed to follow the guidance of the saw if
necessary. Use a pointed bumper when cutting trees and thick branches
can ensure your safety and decrease the work force and vibration level.
If there is an obstacle between the cutting material and the chainsaw, turn
off the machine. Wait until it comes to a complete stop. Wear the safety
glove and remove the barrier. If the chain must be removed, follow the
instructions in the installation part in the manual. A test should be carried
out after cleaning and re-installation. If vibration or mechanical noise is
discovered, please stop use and contact your dealer.

8. MAINTENANCE