Falltech 7009 Manuel De L'utilisateur page 8

5.5.3 Pass Through and Slotted Pass Through Buckles: See Figure 6 for instructions.
Figure 6 - Pass Through and Slotted Pass Through Buckle Instructions
A
A1
A and A1 Grasp each end of the fasteners.
B and B1
Turn the pass-through end of keeper sideways so it will pass into the keeper's holder.
C and C1 Allow the pass-through end to turn back to its correct angle so it will not dislodge from the keeper.
D and D1 To check proper fit, a flat hand may pass under the strap, but cannot form a fist.
Ensure all loose ends are properly tucked into webbing keepers so any loose webbing will not get tangled in equipment.
5.5.4 Quick Connect Buckles: See Figure 7 for instructions.
Verification
window
A
PUSH
Verification indicator (unlocked)
A1
PUSH
A and A1 Grasp the male end of the keeper and the receiver.
B and B1 Insert the male end into the receiver and push to ensure closure.
Check the verification indicators to
C and C1
ensure the male end is properly seated.
Ensure all loose ends are properly tucked into webbing keepers so any loose webbing will not get tangled in equipment.
5.5.5 Confirmation of Proper Fit: Confirm torso length adjustment so the shoulder straps are not applying
unnecessary pressure on the shoulders. Worker should be able to move around freely without the harness
causing restriction in movement.
• Chest strap is six inches below the throat
• Torso length adjustment does not apply unnecessary pressure on the shoulders or allows leg straps
to sag
• Dorsal D-ring is in between the shoulder blades
• Leg straps tightened to allow no more than a flat hand to pass through
MFBH04 Rev A
B
B1
Figure 7 - Quick Connect Buckle Instructions
OPEN Verification
Verification
window
indicator
B
PUSH
PUSH
Verification indicator (locked)
OPEN
B1
PUSH
PUSH
C
C1
LOCKE D
C
PUSH PULL
Verification indicator (locked)
LOCKE D
C1
PULL
PUSH
8
D
D1
Verification
VERIFY
window
LOCK
PULL
VERIFY
LOCK
PULL
121219