Intended Use; Special Safety Instructions - Ayce 1300W Manuel D'utilisation

INTENDED USE

The machine is intended for machining wood and plastic and also for cutting out knots,
cutting grooves, removing recesses, copying curves and logos, etc. The router must
not be used for machining metal, stone, etc.

SPECIAL SAFETY INSTRUCTIONS

1. Hold power tool by insulated gripping surfaces, because the cutter may
contact its own cord. Cutting a "live" wire may make exposed metal parts of
the power tool "live" and shock the operator.
2. Use clamps or another practical way to secure and support the work-piece to
a stable platform. Holding the work by your hand or against the body leaves it
unstable and may lead to loss of control.
3. Always wear a dust mask and ear protection when using this power tool.
4. Use only bits, which are designed for this router.
5. Use only sharp bits that are not chipped or cracked. Blunt bits will cause
stalling.
6. Secure small pieces of wood firmly before working. Never hold them in your
hand.
7. Danger: Keep hands away from the cutting area.
8. Secure the workpiece by means of the clamping equipment.
9. Before staring up, check that the bit is firmly positioned and secured into the
collets.
10. The maximum indicated limit rotation speed of the milling bit must not be
exceeded.
11. Routing must always be carried out against the direction of rotation (bit-
rotation) of the bit.
12. The bit must be running at full speed before lowering into the work-piece.
13. When operating the machine, take great care and always hold the router
handles firmly with both hands. Always provide for a secure footing when
working.
14. Beware of the reaction torque of the machine, particularly if the bit becomes
jammed in the work-piece.
15. On completion of work, allow the machine to slide back to its initial position by
releasing the handle.
16. Make yourself familiar with your working area and be alert for possible
hazards, which you might not hear due to machine noise.
17. Caution: Allow for run down time of bit after turning router off. Wait for the
machine to come to a complete stop before removing from the work piece.
180619_ayce_1328_IM
18. Never slow the router down with your hands.
19. Do not touch the bit immediately after operation; it may be extremely hot and
could burn you.
20. Never stop the router by applying lateral pressure to the bit.
21. Do not force the router. Your router will do a better job if you take it slowly.
22. Avoid cutting nails and screws. Inspect timber and remove all nails and
screws before cutting.
23. In the event of an electrical or mechanical malfunction, immediately switch off
the saw and disconnect the power lead from the mains supply.
82 83 | GB
GB
180619_ayce_1328_IM