Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
b. Installing parallel guide (Fig.2)
Fig. 2
c. Adjusting the depth cut (Fig.3)
The depth of cut is the distance between the depth stop and the depth stop turret.
!
Unplug the router before adjusting the depth stop.
WARNING
Fig. 3
180619_ayce_1328_IM
1. The parallel guide is an effective aid
to cutting in a straight line when
chamfering or grooving.
2. Loosen the screw on the top of the
bar. Align the bar with the hole of the
guide and tighten the screw with a
screwdriver.
3. Loosen two screws for parallel guide
on the base.
4. Feed the bars on the parallel guide
through the holes in the base plate.
5. Adjust the distance between the
router bit and the parallel guide by
moving the guide until it is at the
correct distance.
6. Tighten the screws for parallel guide
to hold the parallel guide in position.
1. Loosen the locking screw so that
depth stop can be moved freely.
2. Push down the plunge lock lever
anti-clockwise and plunge the
router down until the router bit
touches the work-piece, then lock
the router in position by releasing
the plunge lock lever.
3. Move the depth stop down against
the turret depth stop and record the
scale, set to "0".
4. Adjust the depth stop to the
required routing depth, push down
the plunge lock lever anti-clockwise
and guide the router back up again.
The coarse adjustment of the depth-of-cut should be checked by a trial cut and
corrected, if necessary.
Fine adjusting the depth of cut
After a trial cut, fine adjustment can be carried out by turning the fine adjustment knob
(1 scale mark = 0.1 mm/ 1 rotation = 2.0 mm).
d. adjusting the depth stop turret (Fig.4)
Fig. 4
e. Mount dust extraction adaptor (Fig. 5)
Fig. 5
f. Speed adjuster
(Fig.6)
Fig. 6
90 91
|
1. For deep cuts, it is recommended to
carry out several cuts, each with
less material removal.
2. Unplug the router and set the
depth stop turret to the desired
setting. Turn clockwise or counter-
clockwise to lower or raise the
depth stop turret.
1. Fasten dust extraction adaptor to
the base plate with the screws.
2. Fix the extraction adaptor on base
plate.
3. When vacuuming dry dust that is
especially detrimental to health or
carcinogenic, use a special vacuum
cleaner.
With the thumbwheel, the required speed
can be selected (also while running).
1-2
low speed
3-4
medium speed
5-6
high speed
180619_ayce_1328_IM
GB
GB
Publicité
Table des Matières
