Becker Centronic VarioControl VCJ470 Notice De Montage Et D'utilisation page 20

Assembly and Operating Instructions
1) Programming radio channels
1. Connect the VCJ470 to the power supply.
2. Now switch on the power supply.
3. The VCJ470 goes into programming mode for 3 minutes.
1a) Programming master transmitter
When the receiver is in programming mode, press the programming button on
the transmitter and hold for 3 seconds.
The curtain will make a slight movement to confirm programming, i.e. the cur-
tain will move a few centimetres.
This confirmation is referred to as "nodding" in the rest of the operating instruc-
tions.
When the curtain "nods", this signifies that the programming process has been
successfully completed.
Note
If a transmitter has already been programmed in the receiver, press the
programming button and hold for 10 seconds.
1b) Programming additional transmitters
Note
In addition to the master transmitter, up to 15 further transmitters can
be programmed in the VCJ470.
1. Press the programming button of the master transmitter programmed in point
1a) for 3 seconds.
The curtain will "nod" to confirm.
2. Now press the programming button of a new transmitter which has not yet
been programmed in the VCJ470 and hold for 3 seconds. Doing so activates
the programming mode of the VCJ470 for a new transmitter for 3 minutes.
The curtain will "nod" to confirm.
3. Now press the programming button of the new transmitter which you wish to
programme for a further 3 seconds.
The curtain will "nod" to confirm.
The new transmitter has been successfully programmed in the receiver.
20