TEUFELBERGER EXPERT Mode D'emploi page 10

USE
Pic. 3: Safety Junior
EN 361: These harnesses are mainly used for fall
arrest purposes, i.e., they support the
entire body of the wearer and, in the
event of a fall and after arresting a fall,
hold him/her in an upright position.
CAUTION! Use is permitted only in com-
ination with waist belt & shoulder straps.
EN 358: This harness belays its wearer at the work
site (work positioning) or prevents the
wearer from reaching a location from
where he/she can fall down (restraint
function).
A work positioning harness to EN 358
by itself is not suitable for fall arrest
purposes!
In order to provide protection against falls
from a height, it may be necessary to use
configurations including collective
equipment (e.g., safety nets) or personal
protective equipment (e.g., fall protection
systems to EN 363)!
EN 813: This harness holds the body of the user,
who must be conscious, in a sitting posi-
tion.
A sit harness to EN 813 alone is not
suitable for fall protection purposes!
Rather, for protection against falls from a
height, it may also be necessary to use
configurations including collective equip-
ment such as safety nets, or personal
protective equipment such as fall protec-
tion systems to EN 363!
Prior to first use, users should perform a
hanging test in a safe location to verify
that the sit harness has the right size and
offers sufficient adjustment options and a
reasonable level of comfort for the
intended use
10
Pic. 4: Emotion
1. Selecting the right harness size:
Harness size:
Expert Gr.1 leg circumference 52-78 cm /
waist circumference 80-140 cm
Expert Gr.2 leg circumference 52-83 cm /
waist circumference 80-150 cm
Safety leg circumference 52-78 cm /
waist circumference 80-140 cm
Safety Junior leg circumference 40-70 cm /
waist circumference 60-100 cm
Emotion leg circumference 45 -75 cm /
waist circumference 60-130 cm
Maximum nominal load: 130 kg
(= maximum weight of user incl. tools and gear)
CAUTION! When using these products in a fall pro-
tection system, it is imperative to observe the perti-
nent specifications contained in the manufacturer's
information for the products used!
2. Correct use of harness closure and readjust-
ment buckles:
a) 3-bar buckle
Closing the buckle
Pic. 5
1. Insert the loose strap end together with the
insertion buckle through the O buckle from
below. (Pic. 5)
2. Align insertion buckle in parallel with O buckle.
(Pic. 6)
Readjusting (Adapting) harness straps)
Pic. 7
1. Pull end of strap to tighten it (Pic. 7)
2. Pull tongue to loosen it. (Pic. 8)
Pic. 6
Pic. 8