Turn Off; General; Lance And Gun; Water Outlet - Dibo 2D MPU-M Mode D'emploi

5. Turn off

5.1. General

Put the operating switch on OFF when you finish the works.

5.2. Lance and gun

Uncouple the lance and put it away.
Close the water supply.
Roll up the high and low pressure hoses.

5.3. Water outlet

See chapter 1 - safety and 2.1.2.

5.4. Disconnect machine

Operate the DiBO- control.
Press on the stop button (0=OFF).
Switch the electricity on position 0=OFF.
Close the water supply.
Close the pressed air supply (only with a PN3-valve).

5.5. Put away machine

Clean when necessary the water filter.
Put away the manual within reach.
See that the machine is parked frost-proof.

5.6. Transport

Pay attention at transport to the following:
Keeps the machine as much as possible horizontal during transport, one prevents that there leaks oil from the
pump. Load the machine using a lift truck, hydraulic loading platform or a hoist.
Lash the machines (if necessary) sound fixed on the loading platform.

5.7. Transportation at frost

Replace the water sucking hose by a short piece hose and hang it with his end in the anti-frost, so the machine
can suck the anti-frost.
Take the lance from the gun and operate the machine.
Spray until there comes anti-frost out of the gun.
The machine is now filled with anti-frost, stop the machine.
Tip: Because the catch of the outgoing anti-frost water, this can be re-used afterwards.

5.8. Environmentally safe disposal of used fluids

No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed randomly because of the environ-
ment! So make sure, if you are user, that the applicable local guidelines for environmentally friendly disposal of
these fluids (without soil pollution) are complied.
DiBO b.v. 57