Scope Of Application; Turn Off; General; Lance And Gun - Dibo 1D CPU-M/L Mode D'emploi

E N
T U R N O F F

SCOPE OF APPLICATION

Efficient high pressure cleaning is achieved by following a few guidelines
combined with your own experiences. Each cleaning job is different and
specific, therefore contact DiBO for the best solution in your application sector.
• Using cleaning products (if applicable): the surface to clean should be sprayed
so the product can act during some time (do not let it dry!) before cleaning
with high pressure jet. Cleaning agents can increase the cleaning effect if they
are used correctly! Always follow/consider the safety instructions of the used
product!
• Cold water (high pressure) cleaning: removal of (mild) impurities/pollution and
rinsing.
• Hot water (high pressure) cleaning (if applicable): the cleaning effect will be
such improved through increasing the temperature (set the temperature
experimentally according to the application).
• Cleaning via lance with rotating head (if applicable): cleaning method to
remove tough layers of dirt.
• Cleaning using a steam lance (if applicable): this steam function (by
overheating water) is used in 'sensitive' cleaning applications (eg: damage
sensitive surfaces) where there is stubborn dirt (eg: degreaser) is removed by
using steam.
Please note: this application has high cleaning
temperatures and requires various safety measures!

Turn off

GENERAL

Put the operating switch on OFF when you finish the works.

LANCE AND GUN

Uncouple the lance and put it away. Close the water supply. Roll up the high
and low pressure hoses.

WATER OUTLET

Voir chapter "Safety – general warnings" on page 9

DISCONNECT MACHINE

Release the pressure of the hoses by means of pressing the lance. Consult a
DiBO technician for switching off the machine for a long time. This can take
the necessary measures for shutting down the machine for a long time without
damage.

TRANSPORT

1

Algemeen

Pay attention at transport to the following: Keeps the machine as much as
possible horizontal during transport, one prevents that there leaks oil from the
pump. Load the machine using a lift truck, hydraulic loading platform or a hoist.
Lash the machines (if necessary) sound fixed on the loading platform.
2

Transportation at frost

Replace the water sucking hose by a short piece hose and hang it with his end
in the anti-frost, so the machine can suck the anti-frost. Take the lance from the
gun and operate the machine. Spray until there comes anti-frost out of the gun.
The machine is now filled with anti-frost, stop the machine.
Tip: Because the catch of the outgoing anti-frost water, this can be re-used
afterwards.
ENVIRONMENTALLY SAFE DISPOSAL OF USED FLUIDS
No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed
randomly because of the environment! So make sure, if you are user, that the
applicable local guidelines for environmentally friendly disposal of these fluids
(without soil pollution) are complied.
DiBO 20