Operation; Operation Cabinet - Dibo 1D CPU-M/L Mode D'emploi

Operation

OPERATION CABINET

The control cabinet is carried out with main switch, reset button and in use lamp.
Inside the electrical cabinet are the thermal securities of the motors situated.
The can be reached by opening the door of the electrical cabinet, put off the
tension before you open it!
1 M A I N S W I TC H
• The green lamp lights up at IN USE.
• The reset button is carried out as an red push button. The RESET lamp flashes
in the event of a fault. The RESET lamp will illuminate constantly when the
service hours have been reached and no error is present.
2 R E S E T B U T TO N A N D I N U S E L A M P
• Het in bedrijf lamp licht op bij IN BEDRIJF.
• De resettoets is uitgevoerd als een rood verlichte druktoets. De rode RESET
lamp knippert bij een storing. De rode RESET lamp zal constant branden als
de service uren bereikt zijn en er geen fout aanwezig is.
3 D I B O C O M M A N D
The DiBO- control indicates the following:
• Malfunctions (voir "4 Disturbances at DiBO command" on page 18 ).
• Working hours of the machine with necessary next service, see screen below.
Changing the time regulation of the remote control: push on the A button of the
DiBO command. Push on OK and change with the + and - buttons to adjust the
time setting. Next confirm the time setting with OK. Push on ESC to return to the
main screen.
DiBO 17
E N
O P E R AT I O N