Filling Of The Water; Scope Of Application - Dibo 2D MPU-M Mode D'emploi

4.6.4. Filling of the water

If you put the machine in operation and the level is lower than the minimum level or if the tank is empty, than
these will be filled. There must be waited till the tank is filled before one could start the unit.
If the tank is filled, this report will be shown on the screen during a few seconds.

4.7. Scope of application

Efficient high pressure cleaning is achieved by following a few guidelines combined with your own experiences.
Each cleaning job is different and specific, therefore contact DiBO for the best solution in your application sector.
Using cleaning products (if applicable): the surface to clean should be sprayed so the product can act during
some time (do not let it dry!) before cleaning with high pressure jet.
Cleaning agents can increase the cleaning effect if they are used correctly!
Always follow/consider the safety instructions of the used product!
Cold water (high pressure) cleaning: removal of (mild) impurities/pollution and rinsing.
Hot water (high pressure) cleaning (if applicable): the cleaning effect will be such improved through increasing
the temperature (set the temperature experimentally according to the application).
Cleaning via lance with rotating head (if applicable): cleaning method to remove tough layers of dirt.
Cleaning using a steam lance (if applicable): this steam function (by overheating water) is used in 'sensitive'
cleaning applications (eg: damage sensitive surfaces) where there is stubborn dirt (eg: degreaser) is removed by
using steam.
Please note: this application has high cleaning temperatures and requires various safety measures!
DiBO b.v. 56