Kohler SDMO DIESEL 6500 A XL C5 Manuel D'utilisation Et D'entretien page 19

2.7.4 Connection and choice of cables
For all connections, use flexible, strong rubber-sheathed cables which comply with standard IEC 60245-4 or equivalent cables, and
ensure that these are kept in perfect condition. Only use one item of class I electrical equipment per socket and connect up
equipment using a cable equipped with a PE protective conductor (green/yellow); this protective conductor is not required for
class II equipment. Adhere to the cross sections and lengths recommended in this table during installation or when using electrical
extensions.
Equipment type:
Type of unit connector:
Recommended cable cross section:
0 to 50 m
Length of
51 to 100 m
cable used
101 to 150 m*
*This cable length is the maximum permitted length, and must not be exceeded.
Installation method = cables on raceway or non-drilled tablet/Permitted drop in voltage = 5%/Multi-core conductors/Cable type PVC 70°C (e.g.
H07RNF)/Ambient temperature =30°C.
2.8 Risk of hearing loss
DANGER
2.9 Risks during handling operations, use and maintenance
For safety reasons, all operations must be carried out by staff with the necessary skills and using suitable
equipment. Maintenance must be carried out on a regular and conscientious basis, using only original parts. Gloves
must be worn.
Safety guidelines for handling petroleum products:
DANGER
Safety guidelines for handling batteries:
DANGER
1085_EN.docx
10 A
mm² AWG
4 10
10
10
RISK OF HEARING LOSS
Suitable hearing protection must be worn at all times when the unit is running.
RISK OF POISONING OR EXPLOSION
Respect the local regulations in force concerning the handling of petroleum products. Fill up when the
unit is switched off and the engine cold. Smoking, using a naked flame, producing sparks and making
telephone calls are forbidden when filling the tank. After filling, always check that the tank's filler cap is
properly tightened. Clean any traces of fuel with a clean cloth and wait until the vapors have dispersed
before starting the unit. If the fuel is exposed to high temperatures for a period of several hours
(containers or generating set stored in a vehicle parked in the sun, for example), harmful vapors could
be released causing a risk of poisoning or of feeling unwell.
The fluids used by the units, such as oils and fuels, are dangerous products. Never inhale or ingest;
avoid prolonged or repeated contact with the skin.
RISK OF POISONING OR EXPLOSION
Follow the battery manufacturer's recommendations. Only use insulated tools. Keep away from fire or
naked flames. Always ensure adequate ventilation during charging.
Single-phase
16 A
mm² AWG mm²
6 9 10
7 10 7 25
7 16 5 35
15/254
Three-phase
32 A 10 A
AWG mm² AWG
7 1.5 14
3 2.5 12
2 4 10
16 A
mm² AWG
2.5 12
4 10
6 9
2020-08-19