Toro PowerPlex 14in 40V MAX Mode D'emploi page 18

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
After each battery drain
cycle
Yearly or before storage
Checking the Oil Level and
Adding Bar and Chain Oil
Service Interval: Before each use or daily
After each battery drain cycle
1. Place the chain saw on a flat surface and
remove the battery pack; refer to
Battery Pack (page
2. Check the oil level in the window. If you cannot
see oil in the window, add bar and chain oil to
the chain saw (Figure
Figure 27
1. Oil cap
3. Clean the area around the oil cap
Note:
Make sure that you do not allow
debris/wood chips to enter the oil tank.
4. Remove the cap and pour oil into the chain saw
until the oil fills the window
Note:
Do not fill the chain saw higher than the
bottom of the fill neck.
5. Clean up any spilled oil and replace the oil cap.
Maintenance Procedure
• Check the oil level and add bar and chain oil if necessary.
• Check the chain brake.
• Check the chain tension and adjust it if necessary.
• Check the chain for sharpness; contact an Authorized Service Dealer to have the
chain sharpened or replaced.
• Check the oil level and add bar and chain oil if necessary.
• Check the chain brake.
• Check the chain tension and adjust it if necessary.
• Service the guide bar, chain, and drive sprocket.
• Check the chain for sharpness; contact an Authorized Service Dealer to have the
chain sharpened or replaced.
Removing the
15).
27).
2. Window
(Figure 27).
(Figure 27).
Checking the Chain Brake
Service Interval: Before each use or daily
After each battery drain cycle
1. Place the chain saw on a flat surface and
remove the battery pack; refer to
Battery Pack (page
2. Engage the chain brake by moving the chain
brake forward to the
g192110
1. Chain brake (O
position)
3. Grip the chain with a gloved hand and attempt
to pull it around the guide bar; the chain should
not move around the guide bar. If it does, take
the chain saw to an Authorized Service Dealer
for repair.
4. Disengage the chain brake by moving the
chain brake rearward to the O
(Figure 28).
5. Grip the chain with a gloved hand and attempt
to pull it around the guide bar; the chain should
17
Removing the
15).
position
STOP
Figure 28
2. Chain brake (
PERATING
position)
PERATING
(Figure 28).
g192111
STOP
position