Product Overview; Before Using The Chain Saw; Starting The Chain Saw - Toro PowerPlex 14in 40V MAX Mode D'emploi

Product Overview

Left Side of Chain Saw
1. Chain
2. Guide bar
3. Oil window
4. Oil cap
5. Front handle
Right Side of Chain Saw
1. Chain brake
2. Chain tensioning knob
Specifications
Appropriate Temperature Ranges
Charge the battery at
Use products at
Store products at
Unplug the charger if
*Charging time will increase if you do not charge the
battery within this range.
Store the tool, battery pack, and battery charger in an
enclosed clean, dry area.
Figure 4
6. Battery pack
7. Trigger lock
8. Trigger (on rear handle)
9. Guide bar cover
Figure 5
3. Wing nut
0°C (32°F) to 40°C (104°F)*
-15°C (5°F) to 60°C (140°F)
-15°C (5°F) to 60°C (140°F)
Below 0°C (32°F) or above
40°C (104°F)
Operation

Before Using the Chain Saw

Before using the chain saw, do the following:
•
Check the chain tension; refer to
Chain Tension (page
•
Clean and check the chain components for
excessive wear or damage and replace them as
needed; refer to
g192115
and Drive Sprocket (page 18)
Chain (page
•
Check the oil level; refer to
and Adding Bar and Chain Oil (page
•
Check the chain brake; refer to
Chain Brake (page

Starting the Chain Saw

1. Make sure that the vents on the chain saw
(Figure 6
debris.
g192114
1. Vent
1. Vent (inside the battery
cavity)
9
Adjusting the
18).
Servicing the Guide Bar, Chain,
and
20).
Checking the Oil Level
Checking the
17).
and Figure 7) are free from dust and
Figure 6
Figure 7
2. Vent
Sharpening the
17).
g197204
g197205