Platinum Luxury-Lift Battery Backup Assembly Instructions; 1Pl Platinum Luxury-Lift - La-Z-Boy Platinum Luxury-Lift Instructions

Platinum Luxury-Lift
Battery Backup Assembly Instructions
WARNING
– To reduce the risk of serious injury:
• In the event of a power failure, the battery backup provided may not lift the user to a fully
raised position. To ensure lift functionality during a power outage, a battery backup system
must be purchased separately. Contact your La-Z-Boy
Replace the power supply batteries every six months and after each power failure use.
Battery Backup Assembly Instructions
The performance of the built-in battery backup cannot be guaranteed. If you require continuing use
during a power outage, you should purchase a separate battery backup system. Contact your
La-Z-Boy ® dealer for more information.
When operating on battery backup, the only functions the system allows are:
(1) Return the chair to home from any reclined position.
(2) Lift and lower the chair.
(3) Decrease intensity of adjustable lumbar.
To reduce battery consumption, the recline, massage, heat, headrest and increase lumbar intensity
features are blocked and unavailable.
The operating speed is reduced when operating on battery backup.
Always maintain constant, even pressure on the button or toggle when operating on battery backup
to reduce energy consumption.
The built-in battery backup is located in the power supply and uses two 9-volt alkaline batteries
(not included).
1. Unplug the power supply from the electrical outlet and disconnect the power supply
connection at the base of the chair.
2. The battery compartment is located on the side of the power supply. Slide the battery cover
up to access the battery compartment.
3. Place the connection caps over the battery terminals on each battery. Place the batteries in the
compartment, taking care not to damage any wires.
4. Slide the battery cover over the compartment.
5. Proceed to the Operating Instructions.
Platinum Luxury-Lift
Input: 120–240V~,50/60Hz,1.5A
Output: 29V, 2.0A
8
®
® dealer for more information.
Power Supply
Battery
Cover
(2) 9-Volt Alkaline Batteries
Power Supply Specifications:
®

1PL Platinum Luxury-Lift

Operating Instructions
DANGER
– To reduce the risk of serious injury or death:
• Do not let children play on or near the chair when in use. Serious injury or death could
occur if head or body parts are under the chair when the chair is in motion.
• Do not use this product if it is wet, in water, around water or any liquid. Do not handle
the plug or remote control with wet hands.
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
• Keep cord out of reach of small children, and do not use where it may be a trip hazard.
WARNING
– To reduce the risk of serious injury:
• The 1PL, 1PM and 1PH lift chairs are intended for a single occupant, not exceeding 350
pounds. Do not operate the chair with more than one occupant in or on any part of the chair.
• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the back
of the unit. Move the unit into or out of the reclining position slowly, making sure that
no children or pets are in close proximity.
• To safely exit the unit and prevent a tripping hazard, bring the back upright and close
the legrest.
• Unit is designed to ease exit from the chair. Take care to not slip out of chair when
chair is in motion.
NOTICE
– To reduce the risk of product damage:
• After 5 minutes of continuous operation of the 1PL, 1PM and 1PH chairs, allow the lift
and recline features to rest for 5 minutes.
Getting Started
The automatic homing feature returns the lift chair to the seated, home position after the power is
restored following a power interruption. This feature may cause the lift chair to move when plugged
in. Pressing a button or the toggle on the hand wand during the automatic homing cycle interrupts
and stops the cycle, and all button backlights start flashing. Avoid pressing the toggle or any button
during the automatic homing cycle. Refer to the Additional Operating Features for complete
Automatic Homing Details.
Connect the power supply connector to the connector at the base of the lift chair. Connect
the 120 volt power cord to the power supply. Plug the power supply directly into a wall outlet.
Platinum Luxury-Lift ® Operation
The 1PL offers multiple modes of operation. The large, round LIFT and RECLINE button on the front
of the hand wand AND the toggle on the back of the hand wand provide coordinated movements.
The LIFT and RECLINE button and back toggle will operate all functions of the chair in one fluid
movement from sitting, reclining and legrest extension, back to the upright position and standing.
Individual movement of the back and legrest can be achieved by pressing the BACK button to recline
and return the back of the unit, and by pressing the LEGREST button to extend and return the legrest.
(1PL Operating Instructions Continued)
®
9