La-Z-Boy Platinum Luxury-Lift Instructions page 17

Platinum Luxury-Lift
Back Removal Instructions
WARNING
– To reduce the risk of injury:
• The back of the unit must be lifted for assembly and disassembly. Please seek
assistance if you are unable to lift at least 45 pounds without strain.
5. Unlock the back brackets and remove the back; there is one back bracket on each side of the back.
Insert a slotted screwdriver between the back and one of the chair arms and locate the
•
locking lever on the back bracket (F
Carefully pry the back bracket locking lever up to about a 90 degree angle, until unlocked (F
•
Repeat these steps for the other back bracket. Once both back brackets are unlocked, the
•
back is free for removal.
Lift up on the back and remove it from the body.
•
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
6. Reverse these steps to reinstall the back. For easier installation, lay the back across the chair
arms, lift the back at a slight angle to align the back brackets to the body brackets and rotate
the back up, lowering it onto the body (F
and lock both back brackets by pushing the locking lever down, refer to Important note below.
IMPORTANT:
Always make sure the back is properly installed with both sets of back and body brackets
engaged following back removal and reinstallation. To do this, stand behind the chair and
twist the back from side to side. If one or both sides move out of position, the back
brackets are not engaged with the body brackets (F
If you are unable to install the back properly, contact your La Z Boy
32
®
5).
IGURE
6). Verify the back and body brackets are engaged
IGURE
7). Remove the back and reinstall.
IGURE
® dealer for assistance.
F 5
IGURE
Locking Lever
Slotted Screwdriver
Back Bracket
5).
IGURE
F 7
IGURE
Back and Body Brackets Not Engaged--
Remove Back and Reinstall
Platinum Luxury-Lift
Back Removal Instructions
F
IGURE
Body Bracket
®
6
Back Bracket
33