Reclining Chair Assembly Instructions - La-Z-Boy Reclina-Rocker Instructions

Reclining Chair Assembly Instructions

The Assembly Instructions below are for chair backs having upholstery cover attached to all
sides of the back frame. Refer to the instructions on the previous page if your chair back has
upholstery cover attached to all sides of the back frame.
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
Install the chair back
1. Lay the back across the arms of the body. Lift the back at a slight angle and
align the brackets on the back with the brackets on the body (FIGURE 1).
2. Lower the back onto the body, making sure the back and body brackets are
completely engaged.
• To make sure the back is properly installed with both sets of back and
body brackets engaged, stand behind the chair and twist the back
from side to side. If one or both sides move out of position the brackets
are not engaged (FIGURE 2). Remove the back and repeat the steps above.
• If you are unable to install the back properly contact your La-Z-Boy
dealer for assistance.
3. Lock the brackets by using a screwdriver to push down the locking levers (FIGURE 3).
6
®
Reclining Chair Assembly Instructions
F 1
IGURE
Body
Bracket
Back Bracket
F 2
IGURE
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
F 3
IGURE
Back
Bracket
Locking
Lever
Locked
Position
7