La-Z-Time Powerrecline Motion Sofa & Chair Assembly Instructions - La-Z-Boy PowerRecline Instructions

La-Z-Time PowerRecline Motion Sofa &
®
Chair Assembly Instructions
NOTICE:
Do not plug in until instructed.
1. Gently roll the power motion sofa forward to rest on the seat and top arms; if the backs are
attached, roll forward to rest on the top backs. Cut the plastic ties and remove the protective
packaging under each power motor.
2. Remove the twist ties from the motor connector cords. Route the motor connector cords between
the motor cover and the base rail (F
IGURE
3. The power transformer box and the electrical components bag are attached to the back springs on
one of the motion sofa backs. For units with detached backs, lay the motion sofa backs, front side
down, on the seats and lift the outside back upholstery covers to locate the parts (F
backs are attached, pull the lower outside back upholstery cover to release the fastening tape from
the bottom rear rail, and lift the cover to locate the parts. Cut the plastic tie and remove the power
transformer box and the electrical components bag from the back springs.
Remove the power transformer from the box and set aside (F
•
Remove the cords from the bag and set aside. The electrical components bag for the power
•
motion sofa contains two electrical cords: the 120 volt power cord and the dual motor
junction cable (F 3).
IGURE
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
4. Install the backs.
Lay the back on the seat, and locate the back and body brackets (F
•
a slight angle and align the brackets on the back with the brackets on the body.
• Lower the back onto the body, making sure the back and body brackets are completely engaged.
- Lift the back upholstery cover to visually confirm that both sets of back and body brackets
are engaged (F 4). If one or both brackets are not engaged, remove the back and
IGURE
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
Lock the brackets by using a screwdriver to push down the locking levers (F
•
5. Locate the fastening tape on the outside back upholstery cover and the fastening tape on
the bottom of the rear rail (F 6).
IGURE
Pull the outside back upholstery cover down tight, and firmly press the fastening tape
•
on the outside back upholstery cover to the fastening tape on the bottom of the rear rail.
6. Choose a location for the power motion sofa that is close to an electrical outlet.
(PowerRecline Motion Sofa Assembly Instructions Continued)
6
1). Gently roll the sofa back to the upright position.
IGURE
3).
IGURE
2). Lift the back at
IGURE
® dealer for assistance.
5).
IGURE
La-Z-Time
F 1
IGURE
2). If the
Base Motor
Rail Cover
F 3
IGURE
Power 120 Volt
Transformer Power Cord
F 5
IGURE
Back
Bracket
PowerRecline Motion Sofa &
®
Chair Assembly Instructions
F 2
IGURE
Body
Motor Back
Bracket
Connector Cord Bracket
F 4
IGURE
Dual Motor Back and Body
Junction Cable Brackets Engaged
F 6
IGURE
Locking
Lever
Locking
Position
Fastening Tape
Power Transformer Box and
Electrical Components Bag
7