La-Z-Boy PowerRecline Instructions page 9

La-Z-Time PowerRecline
®
Assembly Instructions
NOTICE:
Do not plug in until instructed.
1. Starting with the unit removed from the carton and the back laying off to the side, gently roll
the unit forward to rest on the front or top side of the unit. Cut the plastic ties and remove the
protective packaging under the motor (F
2. Remove the twist tie from the motor connector cord. Route the motor connector cord between
the motor cover and the base rail (F
IGURE
3. Carefully cut the plastic tie holding the power transformer box, hand wand and electrical
components bag to the body bracket on units with an arm or the lower back rail on armless units.
Remove the power transformer from the box and set aside (F
•
Remove the cord(s) from the bag and set aside. The electrical components bag contains the
•
120 volt power cord, and for units with a lighted cup holder, a small Y-cable (F
Unwrap the hand wand and lay it across the seat toward the front of the unit.
•
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
• The back of the unit must be lifted for assembly. Please seek assistance if you are
unable to lift at least 45 pounds without strain.
4. Install the back.
Lay the back front side down on the seat, turn the outside back upholstery cover over, toward
•
the front of the unit, and locate the back and body brackets (F
Lift the back at a slight angle and align the brackets on the back with the brackets on the body.
•
Lower the back onto the body, taking care not to pinch the cables between any metal or wood
•
parts and making sure the back and body brackets are completely engaged.
Note: The back is easier to install when holding it level and lowering it evenly onto
the body brackets.
- Lift the back upholstery cover and look up into the back to visually confirm that both sets of back
and body brackets are engaged (F
IGURE
pinched, remove the back and repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
Lock the brackets by using a screwdriver to push down the locking levers (F
•
(PowerRecline + Motion-Modulars Assembly Instructions Continued)
16
Motion-Modulars
+
1).
IGURE
2). Gently roll the unit back to the upright position.
3).
IGURE
IGURE
4).
IGURE
5). If one or both brackets are not engaged, or if cables are
dealer for assistance.
®
6).
IGURE
La-Z-Time
F 1
IGURE
3).
Motor
F 3
IGURE
120 Volt
Power Cord
* For units with lighted cup holders.
F 5
IGURE
Back and Body
Brackets Engaged
PowerRecline
® +
Assembly Instructions
F
IGURE
Plastic Packaging Base
Ties Rail
F
IGURE
Power Small
Transformer Y-Cable*
F
IGURE
Back
Bracket
Motion-Modulars
2
Motor Motor
Cover Connector Cord
4
Body Back
Bracket Bracket
6
Locking
Lever
Locking
Position
17