Description Of The Product; Installation; Typical System Layout - Nice ROBO Livret D'instructions

1) Description of the product:

This gate and door automation unit controls gearmotors with single-
phase alternating current.
It also features a series of functions that can be selected by Dip-
Switch (mini-switches) and adjustments performed by Trimmers.
A B
O
P
Q
U V
T
1
! If you need to replace a fuse, be careful to use one of the same type and having identical characteristics:
Dimensions (5x20), rated current (e.g. 5A), blowout characteristics (T=delayed, F=quick), maximum voltage and breaking
capacity.

2) Installation:

Automatic gate and door systems may only be installed
!
by qualified fitters in the full respect of the law.

2.1) Typical system layout

In order to explain certain terms and aspects of an automatic door or gate system, we will now illustrate a typical system layout.
2
1
2
C D E
N
R
S
OK
W X
Z
4
The control unit features input status Led's located near such inputs,
while another Led near the microprocessor indicates that the internal
logic works correctly.
To make it easier to recognise the various parts, fig.1 shows the
main components.
F
A Terminal board for aerial
B Function selection Dip-Switch
C Step by step button
D Working Time TL adjustment trimmer
E Pause Time Tp adjustment Trimmer
G
F Input/output control terminal board
G Limit switch input connector
H Flashing light / courtesy light output terminal board.
I Capacitor Connector
H
L Motor power output connector
M Power input terminal board
N Courtesy light mode selector
I
O Radio slot
P Microprocessor
L
Q Low voltage rapid fuse (315mA F)
R Force adjustment trimmer (F)
S OK Led
T Transformer
M
U Triac Open
V Triac Close
W "Common" relay
X "Courtesy light" relay
Z Line fuse (5A F)
Comply with the warnings shown in the "Warnings for
fitters" file.
1) Pair of photocells
2) Flashing lamp
3) Keylock selector
4) Sensitive edge
In particular, please note that:
• All the photocells produced by NICE feature the synchronisation
system which eliminates the problem of interference between
two pairs of photocells (please consult the photocell instructions
for further details).
• The "Photo" pair of photocells have no effect during opening
3
while they reverse movement during closing.
• The triggering of the sensitive edge connected to the "ALT" input
causes an immediate stop and a short reverse run.
GB
5