Nice ROBO Livret D'instructions page 28

Deleting all transmitters
All the memorised codes can be deleted as follows:
Table "B4" Deleting all transmitters
1. Press the receiver button and hold it down
2. Wait for the Led to light up, then wait for it to switch off
and then wait for it to flash 3 times
3. Release the button exactly during the third flash
N.B.: if the procedure was performed correctly, the Led will flash 5 times after a few moments.
Technical characteristics
Receivers
Decoding
Frequency
Input impedance
Outputs
Sensitivity
Working temp.
Transmitters
Buttons
Power input
Absorption
Frequency
Working temp.
Radiated power
16
SMXI
Rolling code
52 bit FLOR
FLOR VERY VR
1 – 2 - 4
12Vdc Batt. 23A 6Vdc lithium batt.
10mA 10mA
SMXIS
Rolling code
64 bit SMILO
433.92MHz
52ohm
4 (on connector SMXI)
better than 0.5µV
-10°C ÷ + 55°CC
FLO
2 1 – 2 - 4
12Vdc Batt. 23°
15mA
433.92MHz
-40°C ÷ + 85°C
100µW
Example
RX
RX
SMXIF
1024 FLO combinations
VERY VE SMILO
2 2 - 4
6Vdc lithium batt. 12Vdc Batt. 23A
10mA 25mA
x3
3°
x5