Mitsubishi Electric PZ-62DR-E Manuel D'instructions page 9

1 Remote controller name
Lossnay is always displayed.
2 Clock
(See the Installation Manual.)
Current time appears here.
3 Fan speed
Fan speed setting appears here.
4 Button function guide
Functions of the corresponding buttons appear
here.
5
Appears when the ON/OFF operation is centrally
controlled.
6
Appears when the filter reset function is centrally
controlled.
7
Indicates when filter and/or Lossnay core needs
maintenance.
8
Appears when the buttons are locked and/or a
fan speed is skipped.
9
Appears when the On/Off timer (Page 24), or
Auto-off timer (Page 26) function is enabled.
0
Appears when the Weekly timer is enabled.
Most settings (EXCEPT ON/OFF, fan speed, ventilation mode) can be made from the Menu
screen. (Refer to page 16)
Page 18
Page 13
Page 50
Page 41
Page 24, 26
Page 28
Eng-9
a
Appears when the night-purge function is
available.
b
Appears when performing operation to protect
the equipment.
c
Appears when performing the power supply/
exhaust function, the delay operation at the start
of operation, or fan speed timer.
d Ventilation mode
Indicates the ventilation mode setting.
e
Appears when external fan speed operation.
f
Appears when operation interlocked with external
unit.
g
Appears when external ventilation mode
operation.
h Temperature or CO
The indicated values are detected value by the
sensor installed in the Lossnay unit.
It could be different from the actual indoor or
outdoor temperature.
Set the display in Display details.
Sensor value indicates in the following
display ranges.
- Outdoor temperature: 2 to 36 ºC
- Return temperature: 9 to 37 ºC
- Supply temperature (calculated value):
9 to 37 ºC
- CO concentration:400 to 2000 ppm
2
"LO" or "HI" indicates when other than
these conditions.
Page 30
Page 13
concentration
2