Ec Declaration Of Conformity - AL-KO BC 4125 II-S Mode D'emploi

en
PROBLEM
Engine starts but does not run
with full performance
Motor runs spasmodically
Excessive smoke
ADVICE
In the case of faults that are not listed in this table, or faults that you cannot rectify without
assistance, please contact our customer service department.

EC DECLARATION OF CONFORMITY

We hereby declare that this product in the form in which it is marketed by us complies with require-
ments of the harmonized EC directives, EC safety standards and the product-specific standards.
Product
Brush cutter
Type
BC 4125 II
Serial number
G 230 2305
Kötz, 6 June, 2012
Antonio De Filippo
Managing Director
22
POSSIBLE CAUSE
Wrong lever position on the
choke
Air filter clogged
Dirty, incorrectly adjusted or
wrong spark plug
Incorrect fuel mixture
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
D-89359 Kötz
EC Directives
2006/42/EC
2004/108/EG
2000/14/EG (13)
2002/88/EG
Sound power level
measured: 116 dB(A)
guaranteed: 119 dB(A)
EC declaration of conformity
CORRECTION
Set the lever to RUN
Clean or exchange the filter
Clean, adjust or exchange the
spark plug
Use the correct fuel mixture
Authorised representative
Anton Eberle
Ichenhauser Str. 14
D-89359 Kötz
Harmonised standards
ISO 11806:2009-01
ISO 14982:1998-09
Conformity assessment
2000 /14/EC Appendix V
BC 4125 II-S