Publicité
English
Cleaning the dispenser units
This procedure should be carried out at the end of the working day on all
dispenser units.
1.
Clean the underpan gasket with a brush.
2.
Fit the blank ring into the filter holder (10), and pour in the
content of a sachet or a measure of detergent powder.
3.
Mount the filter holder (10).
4.
Press one of the coffee dispensing buttons and press the START/
STOP button (20) after few seconds.
5.
Repeat this procedure a few times.
6.
Remove the filter holder (10), and clean the water "shower" with
a sponge.
7.
Rinse for a few seconds with running water from each dispenser
unit.
Cleaning the Filter Holders
All the filter holders should be cleaned at the end of the working day.
1.
Pour 1 litre of cold water and a dose of detergent into a suitable
receptacle.
2.
Remove the filters from the filter holders (10).
3.
Leave the filters and filter holders (10) in the solution for at least
two hours.
4.
Remove any residues with a sponge and rinse in plenty of cold
water.
5.
Refit the filters in the filter holders (10), making sure that the
filter fixing spring is in the correct position.
CAUTION
When the machine has not been used for more than 8
hours, and in any case once a day, the internal
components must be washed before use, in
accordance to the following instructions:
Supply Groups
Fasten the filter-holders (10) to the groups (without coffee)
Allow the water to flow through for approximately one minute,
pressing one of the coffee buttons repeatedly.
Cleaning and maintenance
Grids and drip pan
Remove the grids from the pan (15). Extract and clean them under running
water.
Discharge tank
At the end of the working day, pour a jug of hot water into the discharge
tank to remove any scaling.
Bodywork
The panels must be cleaned with hot soapy water (not boiling) and then
rinsed with plenty of water, removing any organic residue.
Do not use abrasive cloths or substances since they could damage the
surface of the panels.
N.B.: Do not spray any liquids in the slots.
Hot water
Dispense hot water repeatedly until at least 1 liter of water has
been dispensed.
Steam
Allow the steam to flow through the nozzles for approximately
one minute, using the appropriate commands.
2
1
3
English
Publicité
