Publicité
English
Steam dispensing
Plunge the steam jet pipe (6) into the liquid to be heated in a suitable
container and turn the steam adjustment knob (7).
When the liquid is hot, stop the flow of steam by turning knob (7) the
other way (towards “0”).
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark. Then
plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a few
seconds.
When the required amount of froth has been made and the temperature
is sufficiently high, stop the flow of steam by turning knob (7) the
other way (towards “0”).
When the steam jet pipe (6) is no longer required, clean it thoroughly
with a sponge and a clean cloth.
Dispensing hot water
Position a container by the hot water tube (8) and rotate the hot water
regulator knob (9).
Once the container is heated, stop the water flow by turning knob (9)
back (towards “0”).
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
The machine is fitted with a series of automatic level control devices
to keep the water in the boiler at a pre-set level.
The indicator light (11) comes on when water enters the boiler.
To enter the programming phase, keep button (20) pressed for about
10 seconds. The programming phase is indicated by the flashing led
(22).
Once the dosing of the various coffee buttons is completed, press
button (20) for about 1 second to terminate this phase.
“ Before programming the coffee dispensing push buttons
!
fill the filter holder with the correct serving of ground
coffee. Don’t use coffee grouts for programming servings.”
Fit and tighten the filter holder (10) on the coffee dispenser unit,
positioning the cup (or cups) under the nozzle (or nozzles) of the
filter holder (10).
Press (and keep momentarily pressed) the coffee dispensing push
button (16, 17, 18 or 19) corresponding to the required serving to be
programmed.
When the amount of coffee in the cup reaches the required level,
release the coffee dispensing push button.
Repeat the above operations for the other coffee push buttons.
Other hot beverage
Water level control of boiler
How to access the programming function
Programming the coffee measures
7
6
11
22
17
16
English
9
8
20
18
19
Publicité
