Microwave Oven Control; Display; Start; Off/Cancel - IKEA Nutid Série Guide D'utilisation Et D'entretien

Display

When power is first supplied to the microwave oven, a ":" will
blink in the display. Touch OFF/CANCEL to stop the blinking. If
the ":" blinks in the display at any other time, a power failure has
occurred. Touch OFF/CANCEL and reset the clock if needed.
When the microwave oven is in use, the display shows
cooking power, quantities, weights, and/or prompts. When the
microwave oven is not in use, the display shows the time of day.
The Start keypad begins any function. If cooking is interrupted,
touching START will resume the preset cycle.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 1 minute or more. "DOOR" will appear
in the display until the door is opened and closed.

Off/Cancel

The Off/Cancel keypad clears any incorrect command and
cancels most functions except for the Control Lock and Demo
mode. It will not erase the time of day unless the display is in
clock-setting mode. See "Clock" section.
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle.

Add 30 Sec

The Add 30 Sec keypad automatically starts the microwave oven
at 100% power for 30 seconds. Each additional touch of the
control will add 30 seconds of cook time, up to a total cook time
of 10 minutes.
Cook time may be added to a cooking cycle at the current power
level by touching ADD 30 SEC. During a manual cooking cycle,
each touch of the ADD 30 SEC keypad will add 30 seconds of
cook time, up to a total remaining cook time of 10 minutes. The
Add 30 Sec keypad will not add minutes to a cycle that has a
remaining cook time of 10 minutes or more.
Use the dial to select options, set the clock, set cook time and cook
power, select food type and amount/weight, and adjust doneness.
To Use: Push dial and release to pop it out. Repeat to return dial
to its flush position after each use to avoid breakage of the dial.
6

MICROWAVE OVEN CONTROL

Start

Dial

Use the Select keypad to select a chosen function and to set
the following options:
Select a setting or food type and go to the next step.
■
Set or cancel clock. See the "Clock" section.
■
Set weight measurements to oz or lbs.
■
Set amount measurements to pieces, cups, or servings.
■
See the "Meal Prep" sections for details on using the Select
keypad with the automatic cooking, reheating, and defrosting
programs.
This is a standard 12-hour clock (12:00-11:59).
To Set:
1. Touch and hold SELECT for 5 seconds.
"12:00" will appear in the display with the hour (12) flashing.
If you are changing the time, the current set time will appear
with the hour flashing.
2. Turn the dial to set the hour.
3. Touch SELECT or START.
The "minutes" digits will flash in the display.
4. Turn the dial to set the minutes.
5. Touch SELECT or START to complete the setting.
To Cancel Clock:
1. Touch and hold SELECT for 5 seconds.
The clock-setting display will show.
2. Touch OFF/CANCEL.
The ":" will appear in the display.
The next time the clock is set, "12:00" will appear in the display
when the clock-setting mode is entered.
Tones are audible signals that cannot be turned off, and their
volume cannot be changed. These tones indicate the following:
One tone
Reminder, repeat each minute after the end-of-cycle tones.
■
Two tones
Hidden feature has been entered or exited.
■
Three tones
Invalid entry
■
End-of-cycle
■

Select

Clock

Tones