Hoover DUAL POWER MAX PET Guide D'utilisation page 16

PROBLEM POSSIBLE CAUSE
Cleaner won't run 1. Not firmly plugged in
2. No voltage in wall plug
3. Blown fuse or tripped breaker
4. Fuse in cleaner blown
5. On/Off pedal not depressed
Low suction 1. Dirty Water Tank full/automatic shut off engaged
2. Blockage in tool on end of hose
3. Dirty Water Lid not on correctly
4. Dirty Water Tank Debris Filter clogged
5. Blockage in nozzle
6. Recovery Tank not properly secured
7. Recovery Nozzle not on correctly
8. Blockage in hose
1. Clean Water Tank is empty
Hose Nozzle stops spraying liquid during
use
2. Loose connection to connection port on foot of cleaner
Accessory Tool will not spray after filling 1. Air is trapped in the hose & pump
the Clean Water Tank or Solution Tank
Hose will not spray after priming pump 1. Pump is defective
2. Not connected properly
Clean water won't dispense 1. Clean Water Tank not firmly in place
2. Clean Water Tank empty
Brushes won't rotate during floor cleaning 1. Belt is broken
2. Unit in upright position
1. Clean Water Tank or Dirty Water Tank not FIRMLY in place
Water is Leaking out of Carpet Cleaner
16
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse or reset breaker in home.
4. Take to service center.
5. Press pedal.
1. Remove and empty Dirty Water Tank. See "How to Empty" page 10.
2. Remove tool and clear blockage.
3. Make sure lid is on securely. See "How to Clean" page 10.
4. See "How to Clean" page 10.
5. See "How to Clean" page 11.
6. Replace Recovery Tank and secure recovery tank latch.
7. Remove and replace Recovery Nozzle. See "How to Remove & Clean Nozzle" page 11.
8. Drop a coin through, clear with broom handle.
1. Turn off Cleaner and fill Clean Water tank.
2. Check for secure connection to connection port on foot of Cleaner.
1. Turn on the Cleaner. If hose does not spray, prime the pump by lowering the hose down to the floor and hold the
trigger for up to one minute.
2. Aim downward & squeeze trigger.
1. Call for service: 1-800-944-9200.
2. Check connection.
1. Make sure tank is securely locked in position.
2. Refill container according to cleaning instructions.
1. Replace belt. See "Maintenance" page 12 & 13.
2. Brushes will not rotate in upright position. Step on handle release to start cleaning.
1. Make sure the tank is secure.
2. Carpet Cleaner may drip residual moisture after use. Allow unit and brushes to dry before storing on hard floor surface.
WARNING
To reduce the risk of personal injury,
unplug before cleaning or servicing.