Scope Of Delivery - Mettler Toledo InPro 6850i Instructions D'utilisation

InPro 6850 i / 6900 i / 6950 i O
ISM sensors:
All oxygen sensors with the index "i" (6850 i, 6900 i,
6950 i) are equipped with ISM.
Principle: In the sensor head a chip is integrated,
which takes over the entire monitoring and control of
the sensor and, beyond that, stores all sensor data.
This chip is responsed via the transmitter.
The following data are available permanently in the
sensor:
– type of sensor
– serial no.
– software version
– hardware version
– order no.
– operating time
– calibration time and calibration date
– calibration table
To check the system, the following indicators are
supervised:
– temperature
– slope
– zero current
– air current
– polarization voltage
Based on these informations, the transmitter cal-
culates a wear monitor and displays it depending
upon transmitter type differently. (see the respective
instruction manuals)
ISM enables the connection of the digital sensor to
iSense. This user-friendly software allows to manage
all sensor information and store it in a data base.
Furthermore, the sensor can be calibrated via the
iSense software.
3.3

Scope of delivery

Each sensor is supplied fully assembled and factory-
tested for correct function together with:
– a quality control certificate
– inspection certificates 3.1
(complying with EN 10204)
METTLER TOLEDO ISM O
with fitted membrane body but without electrolyte,
covered with the protection cap. They have been
checked for proper function. See electrolyte order
details at section „Spare Parts", 9.3.
Digital sensors must be filled with electrolyte before
start-up.
© 02 / 17 Mettler-Toledo GmbH
Printed in Switzerland
Sensor 12 / 25 mm
2
sensors are supplied
2
InPro 6850 i / 6900 i / 6950 i
13
52 206 349