Clearing Safety Edge Transmitters; Locking The Programming Buttons; Diagnostics; Receiver - SOMFY ROLLIXO io Manuel D'installation

Rollixo io

CLEARING sAfEty EDGE tRANsMIttERs

Press button on the receiver (for approximately 14 s) until the indicator light above it goes out.
Prog
Release button on the receiver during rapid flashing of the indicator light; the indicator light flashes slowly.
Prog
The safety edge transmitter is cleared.
Prog

LoCkING thE PRoGRAMMING ButtoNs

Press buttons and on the receiver until all the indicator lights flash.
Prog
STOP
STOP
Entry into programming mode by pressing button
Entry into motor end limit setting mode via pressing buttons
The parameter setting of the operating modes is locked.

DIAGNostICs

Receiver

Indicator light status
Off
Slow flashing
Rapid flashing
Permanently lit
Indicator light status
fall protection
Motor
Copyright © 2012 Somfy SAS. All rights reserved
Prog
Prog
Press and hold down for 14 seconds
1 2 3 4
Prog
on the receiver is locked.
Prog
and
Meaning
Functional installation
Waiting for an action/adjustment
Deactivation/activation in progress
Installation fault/failure
Diagnostics
Prog
Fall protection is not
connected or there is no
bridge on the connector if
fall protection is connected
to the shared motor terminal
Fall protection triggered
Incorrectly wired motor
Fall protection triggered
(when fall protection is
connected to the shared
motor terminal)
Activated motor thermal
protection
Faulty motor or fuse blown No movement
Waiting for motor
adjustment
Prog
STOP
on the receiver is locked.
Consequences Actions/troubleshooting
No movement Check the fall protection wiring (see page 5).
possible
Check the installation and replace the fall protection.
No movement Check the motor wiring (see page 5).
possible
Check the installation and replace the fall protection.
Wait around 10 minutes.
Check the condition of the fuse and replace it if necessary
possible and (spare fuse supplied, see page 3, point 13). If the motor still
integrated lighting off does not work, replace it.
Set the motor end limits (see pages 7 and 8).
Prog Prog
1 2 3 4
Prog
21