Motor And Fall Protection Wiring - SOMFY ROLLIXO io Manuel D'installation

Rollixo io

Motor and fall protection wiring

The receiver must not be connected to the mains power supply during connection to the motor.
Motor wiring
[1]. Connect the motor to the receiver.
Note: the motor's direction of rotation shall then be checked and reversed if
necessary.
[2]. Lock the motor cable with the cable clamp provided.
The motor cable must be placed in the receiver's 230 V insulation area.
fall protection wiring
If no fall protection is connected, it is essential to create the bridge
between terminals 5 and 6 of the receiver (with the shunt supplied, see
page 3, point 12).
Copyright © 2012 Somfy SAS. All rights reserved
M
L1 N L2
1 2 3 4
230v insulation zone 24v insulation zone
Stop Safety Edge K
Sec
5 6 7 8 9 1
5