General Information; Safety Instructions; Caution - SOMFY ROLLIXO io Manuel D'installation

Rollixo io

GENERAL INfoRMAtIoN

This product, installed in accordance with this guide, complies with the EN 13241-1 and EN 12453 standards.
The instructions referred to in the product's installation guide and instructions for use are designed to prevent damage to property and personal injury along with
compliance with the above standards.
Somfy declares that this product complies with the essential requirements and other relevant provisions of Directive 1999/5/EC. A Declaration of Conformity is
available at www.somfy.com/ce (ROLLIXO io).
Product can be used in the European Union, Switzerland and Norway.

sAfEty INstRuCtIoNs

Caution

Always read this installation guide and the attached safety instructions before installing this Somfy product.
This guide describes how to install, commission and operate this product. Follow all the instructions as incorrect installation can lead to serious injury.
Any use outside the sphere of application specified by Somfy is forbidden. This invalidates the warranty and discharges Somfy of all liability, as does any failure
to comply with the instructions given herein.
This Somfy product must be installed by a professional motorisation and home automation installer, for whom this guide is intended.
Moreover, the installer must comply with current standards and legislation in the country in which the product is being installed, and inform his customers of the
conditions for use and maintenance for the product. It is the installer's responsibility to ensure that the automatic installation and its operation are compliant with
the standards in force.
This device is not designed to be used by persons (including children) whose physical, sensory or mental capacity is impaired, or persons with little experience
or knowledge, unless they are under supervision or have received instructions on using the device by a person responsible for their safety. Children should be
supervised to ensure they do not play with the device.
safety instructions
Pre-installation checks
The product must not be fitted in an area prone to water splashes.
Check there are no dangerous parts accessible on the door. If this is the case, protect them.
Installation
Before fitting the receiver, refer to the safety instructions for the RDO CSI motor.
With RDO CSI motors, the receiver must be fitted inside the garage.
The receiver and non-locking switches must be installed in direct view of the door, but away from moving sections. The minimum height at which they must be
installed is 1.5 m and they must not be accessible to the public.
Place the fixed control devices and remote controls out of the reach of children.
The safety instructions must be followed throughout the installation:
• Take off any jewellery (bracelet, chain, etc.) during installation.
• For drilling and welding operations, wear special glasses and appropriate protection.
• Use the appropriate tools.
• Be careful when handling the motorisation system to prevent any risk of injury.
• Do not connect to the mains before completing the assembly process.
• Never use high water pressure cleaning equipment.
After installation, ensure that:
• the mechanism is correctly adjusted,
• the protection system and any manual back release system operate correctly
• the motorisation changes direction when the door encounters an obstacle 40 mm high positioned on the ground.
Power supply
In order to operate, the motorisation must be supplied with 230 V 50 or 220 V 60 Hz. The electric line should:
• be exclusively reserved for the motorisation,
• have a minimum cross-section of 1.5 mm²,
• be fitted with an approved all-pole switch with contact openings of at least 3.5 mm, fitted with a protection device (fuse or circuit breaker with a 16 A rating) and
a differential device (30 mA),
• be installed in accordance with the current electrical safety standards,
• be fitted with a lightning conductor (in compliance with standard NF C 61740, maximum residual voltage 2 kV),
Check whether the earthing system is installed correctly: connect all the metal parts of the assembly and all the components of the installation equipped with
earth terminals.
safety devices
The selected safety accessories for the installation must comply with the current standards and regulations in force in the country in which the product is being
installed. The use of any safety components not approved by Somfy remains the sole responsibility of the installer.
If the garage door faces a public road, fit an orange light type signalling device.
The bottom of the door must be fitted with a safety edge compatible with the Rollixo system.
Install all the safety devices (photoelectric cells, safety edges, etc.) required to protect the zone from the danger of crushing, entanglement and cutting according
to the applicable directives and technical standards.
In accordance with standard EN 12453 governing the safe use of motorised gates and doors, the use of the TAHOMA control box to automatically control a
garage door or gate not visible to the user requires the installation of a photoelectric cell type safety device with autotest on the automatic control system.
Maintenance
Before carrying out work on the installation, switch off the power supply.
Use only original parts for any maintenance or repair work.
2
Copyright © 2012 Somfy SAS. All rights reserved