Installing And Commissioning A Radio Optical Safety Edge; Installing The Safety Edge And Its Transmitter; Memorising The Optical Safety Edge Transmitter; Installing And Commissioning A Resistive Radio Safety Edge - SOMFY ROLLIXO io Manuel D'installation

Rollixo io
INstALLING AND CoMMIssIoNING AN oPtICAL RADIo sAfEty EDGE

Installing the safety edge and its transmitter

Follow the instructions provided with the optical safety edge transmitter (OSE) and the safety edge installation kit.

Memorising the optical safety edge transmitter

[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog
indicator light will flash and then go out (this may take a few seconds,
the time required for the transmitter and receiver to communicate with
each other).
The transmitter is memorised in the receiver.
[3]. optional: the lower magnet must be installed if the ground is uneven
and causes erratic obstacle detection.
Press the button to move the garage door to the bottom position,
then secure the lower magnet to the edge of the runner, positioning it
in line with the transmitter.
This operation is important. Ensure the alignment is observed.
Move SW3 dipswitch 1 on the transmitter to ON.

INstALLING AND CoMMIssIoNING A REsIstIvE RADIo sAfEty EDGE

Installing magnets on the runner

To function correctly, this solution requires the installation of a set of magnets
on the runner
[1]. Press button
to position the garage door in the upper position.
 E nsurethesafetyedgetransmitterisnotfixedtoitsplate.
Copyright © 2012 Somfy SAS. All rights reserved
1 2 3 4
STOP Prog
4s
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
1 2 3 4
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
10 mm maxi.
BOTTOM
magnet
ON
1 2 3 4
TOP magnet
Safety edge
transmitter mounting
plate
BOTTOM magnet
9