Memorising The Keytis Io Remote Controls - SOMFY ROLLIXO io Manuel D'installation

Rollixo io

Memorising the keytis io remote controls

TheKeytisioremotecontrolsystemkeymemorisingandcopymemorisingoperationscanonlybecarriedoutattheinstallationsite.Toobtain
authorisation to transfer its system key or programming, the previously memorised remote control must be able to establish radio communication
with a receiver on the installation.
If the installation already includes other io-homecontrol
remotecontrolmustfirstmemorisethesystemkey(seebelow).
Memorising the system key
. This step must be performed if the installation already includes other io-homecontrol
remote control.
.IftheKeytisioremotecontroltobememorisedisthefirstremotecontrolonthesystem,godirectlytothestep"MemorisingtheKeytisio
remotecontrol".
[1]. Setting the memorised remote control to key transfer mode:
• Keytis io, Telis io, Impresario io, Composio io remote controls: press the "kEy" button until the green indicator light comes on (2 s).
• Other remote control: refer to the instructions.
[2]. Briefly press the "kEy" button on the new remote control. Wait for the confirmation beep (a few seconds).
Memorising via the programming interface
If the installation already includes other io-homecontrol
first memorise the system key (see above).
[1]. Press the button on the receiver until the indicator light comes on permanently.
Prog
[2]. Briefly press the "PRoG" button on the remote control.
Wait for the second beep and the green indicator light to start flashing rapidly.
This may take from a few seconds up to around 1 minute, depending on the number of products present in the system.
[3]. Briefly press the selected button to actuate the motorisation within a maximum time delay of 10 seconds.
The remote control emits a confirmation beep and the Prog indicator light on the receiver flashes; the remote control is memorised in the receiver.
[1]
Prog
Memorising by copying a previously memorised keytis io remote control
Complete copying of a keytis io remote control
This operation is used to copy all the buttons on a previously memorised remote control.
The new remote control must not be memorised for another automatic control system.
Ensure that the new remote control has memorised the system key.
[1]. Press the "PRoG" button on the memorised remote control until the green indicator light comes on (2 s).
[2]. Briefly press the "PRoG" button on the new remote control.
Wait for the second beep and the green indicator light to start flashing rapidly (a few seconds).
[1]
Remote control memorised
18
®
Remote control memorised
products with at least one memorised bidirectional remote control, the Keytis io remote control must
®
[2]
Prog
[2]
Remote control to be memorised
 products with at least one memorised bidirectional remote control, the Keytis io
®
Remote control to be memorised
products with at least one memorised bidirectional
[3]
Copyright © 2012 Somfy SAS. All rights reserved